garyafcb
08-03-2006, 12:00 AM
Had the strangest incident with my board.
When I switched on the projector in the morning the image on my board crept sideways in 3 or 4 small jumps so that about 15% of the image had disappeared.
No amount of re-calibrating the projector or board would stop it happening.
So phoned tech support.
Very quickly fixed by switching the board off for 30 seconds and then back on again.
Problem solved - apparently the chip on the board can occasioonally get corrupted.
Our boards are never switched off - so obviously chances of a problem must increase over time.
So if your boards are left on - and your image goes walkies - you know what to do :cool:
When I switched on the projector in the morning the image on my board crept sideways in 3 or 4 small jumps so that about 15% of the image had disappeared.
No amount of re-calibrating the projector or board would stop it happening.
So phoned tech support.
Very quickly fixed by switching the board off for 30 seconds and then back on again.
Problem solved - apparently the chip on the board can occasioonally get corrupted.
Our boards are never switched off - so obviously chances of a problem must increase over time.
So if your boards are left on - and your image goes walkies - you know what to do :cool: